|
|
|
SuraFlow-GutterGuard SIMPLE INSTALLATION INSTRUCTIONS Firstly, ensure that you have a minimum of 35mm between the bottom of your roof tiles and the top of your gutter (see below - Gutter Alignment). SuraFlow-GutterGuard is simple to install, using a spacer clip at the rear of the gutter and a spacer clip at the front. The guard is ‘fixed’ every length (2 metres) using a self tapping screw through the front of the gutter and picking up on the downward leg of the guard. This fixing stops any possibility of the guard lifting in the wind. Lengths of SuraFlow-GutterGuard are joined together using
the supplied joiner and butted up to each other. They do not need to be sealed. Corners are formed by cutting a mitre and using a corner
joiner. Corners are available pre-cut. Endcaps are screwed into the joiner channels at end of the
guard. Gutter Alignment
.
|
|
Send mail to webmaster@suraflow.co.uk with questions or comments about this web site. All content is copyright of Younger Marketing Management LimitedSuraFlow is the Registered Trademark of Younger Marketing Management Limited - Co Reg: 4085824 - DPA Reg: Z7629401 - OFT Licence: 533293Last modified: September 16, 2007 |